PulyCaf, Cafiza and CleanCaf are only for cleaning coffee and back
flushing commercial machines. If you are using these two as
descaling chemicals it can harm the
The instructions below,
apply to the following models:
Caffe Charisma, Gaggia's
Syncrony Compact, Spidem's Divina, Divina Deluxe
and Divina Digital
Italia & Incanto Grinder Cleaning
Step-1: Remove beans that are in the bean
hopper without spilling them inside. (Use Vacuum).
Step-2: Remove the beans container by
removing 3 phillips head screws. Remove the rubber gasket from below
the hopper. At this stage the upper burr will be
Step-3: Rotate counter-clockwise the
outer ring of the grinder assembly (the ring has gears half way
around), until the red mark is at the 9 o’clock position, looking at
it from the front of the machine.
Step-4: Lift the upper burr by using the
fins that are on top. Press lightly on the doser adjustment gear, to
clear it from the dose adjustment gear.
At this stage, the grinding chamber will be exposed. Clean
out any crushed coffee in the grinder chamber and the burrs. Use
Vacuum and cleaning brush.
Step-1: With the red mark on the outer
ring still at the 9 o’clock position, replace the upper burr back
into the grinder. Make sure that the red line (on the upper burr) is
at the 3 o’clock position. This position will align the other tabs
as well. During re-installation, press slightly on the doser
adjustment gear so the upper burr will clear it as it is placed back
Step-2: With the Upper burr in place,
rotate the outer ring clockwise until it stops. The two red marks
should be aligned at the 3 o’clock position underneath the doser
Step-3: Replace the soft rubber gasket
back on the upper burr. Use the fins to align it properly.
Step-4: Slide the doser adjustment gear
toward the front of the machine until it
Step-5: Before replacing the bean hopper,
rotate the grinder adjustment wheel to Zero (0), and the doser
adjustment wheel to Minus symbol (-). Place the bean hopper into
position on the machine, slightly adjusting each adjustment wheel as
you are placing it down in the machine. Once in place, fasten the
bean container with the 3 screws. Test each adjustment wheel through
the full range of motion. The grinder knob rotates from 0 to 18 and
back, and doser knob from Minus (-) to Plus (+) and
Now position the grinder adjustment knob
at Eight (8) and the doser adjustment knob to the halfway point
between the Plus (+) and the Minus (-) marks. This will put the
machine back to the factory setting.
When using for the first time after
adjusting the grinder, it may take more than one grinding cycles to
make the first cup of coffee.
there are any questions, please call Services Unlimited, Inc.
at 1-888-950-4878 or
e-mail at firstname.lastname@example.org.